Advant OCS SNAT 607MCI 61027769F ABB Multi Channel Interface Board 8 Differential Inputs

SNAT 607MCI (ABB PN 61027769F) is a multi-channel pulse and communication interface board for Advant OCS racks. It conditions high-speed encoder/tachometer signals, distributes them to the CPU, and provides isolated RS-485/RS-422 serial links—eliminating external converters and reducing wiring by >30% in paper, metals, power and marine applications.

• 8 differential inputs - encoder/tacho A, /A, B, /B, 250 kHz max
• 24 V push-pull outputs - 8 channels, 0.5 A peak, short-circuit proof
• Isolated serial port - RS-485/RS-422, 115.2 kbaud, Modbus-RTU slave
• Multi-voltage inputs - 5 V or 24 V selectable by jumper
• Plug-and-play - DIN-rail clip, 24 VDC supply, LED diagnostics
• Wide temperature - 0…+70 °C operating, -40…+85 °C storage
• Global approvals - CE, UL 508, ABS marine, RoHS, REACH

• Paper machine sectional drive pulse distribution
• Metals rolling-mill stand speed references
• Power-plant coal-mill feeder drives
• Marine thruster encoder links (ABS certified)
• Retrofit of legacy Advant Controller 31x/41x/51x racks

• Controllers: AC 31x, AC 41x, AC 51x (Advant OCS)
• Rack: 07 KR 91, 07 KT 92, 07 SK 50 (1-slot width)
• Drives: DCS 500/600/800, ACS 600/800 (early firmware)
• PLC Interface: CI930F, CI867K01 via Modbus-RTU
• Legacy Boards: 07 SK 50, 07 KR 91, 07 KT 92 with adaptor cable 3BSE018114R1

1. Slide board into 35 mm DIN-rail inside rack; latch until click.
2. Set jumpers - choose 5 V or 24 V input level; terminate RS-485 if last node.
3. Wire encoder - use shielded twisted-pair, shield earthed at board only.
4. Connect 24 V - observe polarity; green "PWR" LED lights.
5. Configure controller - select "EXT PULSE" source, set pulses/revolution.
6. Verify pulses - oscilloscope on output terminals should show clean square wave.